The 7-Step Backup Camera Installation Process Step 1: Take The Car Apart Having the right tools enables you, to carefully and cleanly remove parts of the vehicle, which are necessary for a successful installation. You will need screwdrivers, pliers, pin and trim removal tools, depending on your type of vehicle. Radioshack phone recorder controller manual install#Check to confirm if your vehicle controls your brake light, using a CAN Bus, because if it does, then you don’t need to install a trigger cable. Whenever available, the monitor uses the trigger cable to know when to switch to the camera’s feed. Trigger cables are single wires that run from a video monitor to the reverse light of a car. The Controller Area Network, also referred to as CAN Bus, is a system used by car makers to make wiring easier in a vehicle. In such a case, you will have to get an adapter. You can check your vehicle’s manual for clarification.Īlthough the video input would mostly be a yellow-colored female RCA plug, some car makers can also have unique plugs for their system’s video input. This is the first step, because if your head-unit can’t handle video, then there is no need to continue. They are as follows: – Confirm Your Radio’s Video Input In order to guarantee your success with this install, there are a few prerequisites that you must have to attend to, before moving on. There could be other conditions for installing the camera, but this guide assumes that your vehicle already has a monitor installed. And if you would love to install a camera, or to just upgrade an existing one, then this guide is for you. If your vehicle lacks a backup camera, but has a radio with a video monitor.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |